FlightSimBuilder G1000 Multi-Profile Simulator Setup Instructions

Assembly and Setup – G1000 Multi‑Profile Simulator

Step 1 – Assemble NLR Flight Stand Pro

Assemble the Next Level Racing Flight Stand Pro using the instructions included in its box.

Step 2 – Assemble NLR Flight Seat Pro

Assemble the Next Level Racing Flight Seat Pro using the instructions included in its box.

Step 3 – Install extension plate

Attach the extension plate (included with the Flagship panel) to the top of the NLR Flight Stand Pro.

Step 4 – Mount Flagship panel

Place the Flagship panel on top of the extension plate and align all mounting holes. Secure the panel to the extension plate using the supplied hardware.

Step 5 – Install Honeycomb Alpha and Bravo

Insert the Honeycomb Alpha yoke and Bravo throttle into the Flagship panel cutouts and position them as desired. Secure both controls to the stand using the Honeycomb mounting hardware, with the extension plate sandwiched between the stand and the panel.

Step 6 – Install G1000 units and audio panel

Insert the FlightSimBuilder G1000 units and audio panel into the corresponding cutouts in the Flagship panel. Secure each unit with the provided screws, tightening them evenly until snug (do not overtighten).

Step 7 – Display connections

Connect your PC to the monitors using DisplayPort cables from the graphics card outputs to each display.

Step 8 – G1000 video and USB connections

Connect each G1000 unit’s HDMI output to the USB‑to‑HDMI splitter (or adapter) as supplied with your bundle, then connect the splitter to the PC. Ensure all required USB leads from the splitter or G1000 units are plugged into the PC or a powered USB hub.

Step 9 – Controls and audio panel to PC

Connect the Honeycomb Alpha, Honeycomb Bravo, and FlightSimBuilder audio panel USB cables to the PC (preferably to a powered USB hub or rear motherboard ports).

Step 10 – Install simulator software

Install Microsoft Flight Simulator and/or X‑Plane on the PC and complete any first‑run setup and updates.

Step 11 – Continue with G1000 software setup

Complete the G1000 configuration using the official FlightSimBuilder G1000 instructions page:

- General setup (USB/HDMI/power, PFD/MFD role selection, backlight control)

- MSFS section (Launcher, pop‑out windows, screen fill, pop‑out manager addon)

- X‑Plane section (Launcher, .joy profiles, no‑bezel textures, undocking and moving the G1000)

Use this page for all software‑side steps: https://flightsimbuilder.com/pages/flightsimbuilder-g1000-instructions

Step 12 – Included technical support

There are 5 hours of technical support included with your purchase. Please contact us at this point if you need any help with software or simulator setup, or if you have any other questions or need guidance; an engineer will connect to your PC remotely and assist you with the configuration.